Electrical engineering

Printed circuit board

Physics

Geology

Fabrication

Pathology

Nanotechnology

Laser

Etching (microfabrication)

Optics

Inkwell

Oceanography

Electronic circuit

Engineering

Electronics

Engraving

Composite material

Materials science

Alternative medicine

Substrate (aquarium)

Polydimethylsiloxane

Layer (electronics)

Computer science

Integrated circuit

Flexible electronics

Optoelectronics

Medicine

Bioengineering

Conventional patterning methods for producing liquid metal (LM) electronic circuits, such as the template method, use chemical etching, which requires long cycle times, high costs, and multiple-step operations. In this study, a novel and reliable laser engraving micro-fabrication technology was introduced, which was used to fabricate personalized patterns of LM electronic circuits. First, by digitizing the pattern, a laser printing technology was used to burn a polyethylene (PE) film, where a polydimethylsiloxane (PDMS) or paper substrate was used to produce grooves. Then, the grooves were filled with LM and the PE film was removed; finally, the metal was packaged with PDMS film. The experimental results showed that the prepared LM could fabricate precise patterned electronic circuits, such as golden serpentine curves and Peano curves. The minimum width and height of the LM circuit were 253 μm and 200 μm, respectively, whereas the printed LM circuit on paper reached a minimum height of 26 μm. This LM flexible circuit could also be adapted to various sensor devices and was successfully applied to heart rate detection. Laser engraving micro-processing technologies could be used to customize various high-resolution LM circuit patterns in a short time, and have broad prospects in the manufacture of flexible electronic equipment.

Laser-Engraved Liquid Metal Circuit for Wearable Electronics