Electrical engineering

Physics

Meteorology

Total harmonic distortion

Agronomy

Biology

Induction generator

Gene

Inverter

Engineering

Voltage

Artificial intelligence

Wind speed

Controller (irrigation)

Control (management)

Chemistry

Permanent magnet synchronous generator

Variable speed wind turbine

Turbine

Pitch control

Computer science

Electronic speed control

Wind power

Blade pitch

Maximum power point tracking

Control theory (sociology)

Biochemistry

Robustness (evolution)

Mechanical engineering

Energies

Wind speed variations affect the performance of the wind energy conversion systems (WECSs) negatively. This paper addressed an advanced law of the backstepping controller (ABC) for enhancing the integration of doubly fed induction generator (DFIG)-based grid-connected WECS under wind range of wind speed. This enhancement was achieved through three control schemes, which were blade pitch control, rotor-side control, and grid-side control. The blade pitch control was presented to adjust the wind turbine speed when the wind speed exceeds its rated value. In addition, the rotor and grid-side converter controllers were presented for improving the direct current link voltage profile and achieving maximum power point tracking (MPPT) under speed variations, respectively. To evaluate the effectiveness of the proposed ABC control, a comparison between PI and sliding-mode control (SMC) was presented, considering the parameters of a 1.5 MW DFIG wind turbine in the Assilah zone in Morocco. Moreover, some changes in the DFIG parameters were introduced to investigate the robustness of the proposed controller under parameter uncertainties. Simulation results showed the capability of the proposed ABC controller to enhance the performance of the DFIG-WECS based on variable speed and variable pitch turbine, at both below and above-rated speed, leading to an error around 10−3 (p.u), with an ATE = 0.4194 in the partial load region; in terms of blade pitch control, an error of 2.10−4 (p.u) was obtained, and the DC-link voltage profile showed a measured performance of 5 V and remarkable THD value reduction compared to other techniques, with a measured THD value of 2.03%, 1.67%, and 1.46% respectively, in hyposynchronous, hypersynchronous, and pitch activation modes of operation. All simulations were performed using MATLAB/SIMULINK based on real wind profiles in order to make an exhaustive analysis with realistic operating conditions and parameters.

Nonlinear Control Strategies for Enhancing the Performance of DFIG-Based WECS under a Real Wind Profile