Bone tissue

Cell biology

Biology

Simulated body fluid

Biomedical engineering

Metallurgy

Materials science

Calcium

Ceramic

Magnesium

Regeneration (biology)

3D printing

Biochemistry

Phosphate

Polymer

3d printed

Magnesium phosphate

Polycaprolactone

Composite material

Medicine

Chemistry

Scanning electron microscope

Extrusion

Biodegradable polymer

Biomaterials

One of the important challenges in bone tissue engineering is the development of biodegradable bone substitutes with appropriate mechanical and biological properties for the treatment of larger defects and those with complex shapes. Recently, magnesium phosphate (MgP) doped with biologically active ions like strontium (Sr2+) have shown to significantly enhance bone formation when compared with the standard calcium phosphate-based ceramics. However, such materials can hardly be shaped into large and complex geometries and more importantly lack the adequate mechanical properties for the treatment of load-bearing bone defects. In this study, we have fabricated bone implants through extrusion assisted three-dimensional (3D) printing of MgP ceramics modified with Sr2+ ions (MgPSr) and a medical-grade polycaprolactone (PCL) polymer phase. MgPSr with 30 wt% PCL (MgPSr-PCL30) allowed the printability of relevant size structures (>780 mm3) at room temperature with an interconnected macroporosity of approximately 40%. The printing resulted in implants with a compressive strength of 4.3 MPa, which were able to support up to 50 cycles of loading without plastic deformation. Notably, MgPSr-PCL30 scaffolds were able to promote in vitro bone formation in medium without the supplementation with osteo-inducing components. In addition, long-term in vivo performance of the 3D printed scaffolds was investigated in an equine tuber coxae model over 6 months. The micro-CT and histological analysis showed that implantation of MgPSr-PCL30 induced bone regeneration, while no bone formation was observed in the empty defects. Overall, the novel polymer-modified MgP ceramic material and extrusion-based 3D printing process presented here greatly improved the shape ability and load-bearing properties of MgP-based ceramics with simultaneous induction of new bone formation.

Tough magnesium phosphate-based 3D-printed implants induce bone regeneration in an equine defect model