Annealing (glass)

Amorphous solid

Acrylonitrile butadiene styrene

Laminar flow

Materials science

Toughening

Thermodynamics

Physics

Thermal

Fracture toughness

Composite material

Crystallography

Chemistry

Meteorology

Toughness

Polymer

Polymeric structures fabricated using Fused Filament Fabrication (FFF) suffer from poor inter-laminar fracture toughness. As a result, these materials exhibit only a fraction of the mechanical performance of those manufactured through more traditional means. Here we show that thermal annealing of confined structures manufactured using the FFF technique dramatically increases their inter-laminar toughness. Single Edge Notch Bend (SENB) fracture specimens made from acrylonitrile-butadiene-styrene (ABS) feedstock were isothermally heated in a supporting fixture, post-manufacture, across a range of times and temperatures. Fracture testing was then used to quantify the changes in inter-laminar toughness offered by annealing through measurements of the Mode I critical elastic-plastic strain energy release rate, JIc. Under the most aggressive annealing conditions, the inter-laminar toughness increased by more than 2700% over the non-annealed baseline material. Void migration and aggregation during the annealing process was analyzed using X-ray tomography and provides insight into the toughening mechanisms. Time-scales of reptation and polymer mobility at the interface during annealing are also modeled and agree with fracture experiments.

Increased fracture toughness of additively manufactured amorphous thermoplastics via thermal annealing