Methane

Drilling

Engineering

Nanoparticle

Metallurgy

Materials science

Mineralogy

Petroleum engineering

Chemical engineering

Geology

Drilling fluid

Nanotechnology

Organic chemistry

Ultrapure water

Chemistry

Clathrate hydrate

Nucleation

Hydrate

Journal of Energy Chemistry

Invasion of drilling fluid into natural gas hydrate deposits during drilling might damage the reservoir, induce hydrate dissociation and then cause wellbore instability and distortion of the data from well logging. Adding nanoparticles into drilling fluid is an effective method in reducing the invasion of drilling fluid and enhancing borehole stability. However, the addition of nanoparticles might also introduce hydrate formation risk in borehole because they can act as the “seeds” for hydrate nucleation. This paper presents an experimental study of the effect of hydrophilic silica nanoparticle on gas hydrate formation in a dynamic methane/liquid-water system. In the experiment, the ultrapure water with and without 1.0 wt%–6.0 wt% concentrations of silica nanoparticles, grain sizes of 20 and 50 nm, were pressurized by methane gas under varied conditions of temperature and pressure. The induction time, the gas consumption, and the average rate of gas consumption in the system were measured and compared to those in ultrapure water. The results show that a concentration of 4.0 wt% hydrophilic SiO2 particles with a grain size of 50 nm has a relatively strong inhibition effect on hydrate formation when the initial experimental condition is 5.0 °C and 5.0 MPa. Compared to ultrapure water, the hydrophilic nano-SiO2 fluid increases the induction time for hydrate formation by 194% and decreases the amount and average rate of hydrate formation by 10% and 17%, respectively. This inhibition effect may be attributed to the hydrophilicity, amount and aggregation of silica nanoparticle according to the results of water activity and zeta potential measurements. Our work also elucidates hydrophilic, instead of hydrophobic, nanoparticles can be added to the drilling fluid to maintain wellbore stability and to protect the hydrate reservoir from drilling mud damage, because they exhibit certain degree of hydrate inhibition which can reduce the risk of hydrate reformation and aggregation during gas hydrate or deep water drilling if their concentration can be controlled properly.

Effect of hydrophilic silica nanoparticles on hydrate formation: Insight from the experimental study