Water hammer

Materials science

Tube (container)

Vortex

Thermodynamics

Physics

Cavitation

Pressure measurement

Static pressure

Composite material

Turbine

Meteorology

Mechanics

Draft tube

Physics of Fluids

During the transient processes in load rejection in a pumped-storage system, water column separation (WCS) can occur in the draft tube when the local pressure is less than the vapor pressure. The reverse water hammer due to water column bridging affects the safety of the unit and the tailrace tunnel. However, what are the conditions that trigger WCS? What is the physical mechanism? These questions have not been elucidated experimentally. Therefore, it is necessary to investigate the conditions that lead to WCS and the impact of the reverse water hammer generated by WCS bridging on the stability of the unit. In this study, a semi-open test rig was modified by installing a variable-frequency pump to reduce the static pressure, resulting in a cavitation vortex in the draft tube. The static pressure and the water hammer pressure derived from load rejection cause the pressure at the draft tube wall to fall below the vapor pressure for some time, interrupting the flow in the draft tube. This is a typical case of WCS in a pump turbine. If the pressure in the draft tube does not remain at the minimum pressure for long enough, imperfect water column separation may occur with bubble groups. The amplitude of the pressure pulsations during the initial and development stages was (−0.2 m, 0.2 m). It was 4.96% of the initial static pressure. Thus, the pressure fluctuations have a negligible effect on WCS.

Experimental study of cavitating vortex rope and water column separation in a pump turbine