Active layer

Sediment

Process (computing)

Engineering

Waviness

Heat transfer

Biology

Materials science

Deposition (geology)

Layer (electronics)

Thin-film transistor

Operating system

Active cooling

Computer science

Heat exchanger

Porosity

Paleontology

Mechanical engineering

Genetics

Thermodynamics

Physics

Thermal

Polarity (international relations)

Composite material

Cell

Meteorology

Mechanics

Water cooling

Journal of Manufacturing Processes

Thermal management is a key factor in wire + arc additive manufacturing (WAAM) in order to mitigate heat accumulation and cope with limitations regarding deposition cycle, geometry issues, and mechanical property anisotropies. From the process point of view, the variable polarity Cold Metal Transfer process, a variant of the Gas Metal Arc (GMA) deposition process named as CMT Advanced, stands out as a prominent option to reduce the heat transferred to the layers under deposition, without dropping the deposition rate. In another front, thermally managing the component by employing a technique called Near Immersion Active Cooling (NIAC) throughout all the deposition time has shown to be a promising tool to remove heat from the part under construction. Thus, the current work proposes an evaluation of the CMT Advanced process combined with the NIAC technique for WAAM. The deposition of Al alloy wall-like preforms was made by varying the positive and negative polarity ratio (EP/EN) in the CMT Advanced process and the layer edge to water distance (LEWD) in the NIAC technique. Comparative runs were made with natural cooling instead of the NIAC technique. Electric signals and porosity were quantified to verify the constancy of the process. Thermal cycles of a fixed point of the walls and some of their geometrical features were measured to see the effect of the EP/EN and LEWD parameters in terms of thermal management performance. For the deposition circumstances applied, minor lack of coalescence between layers and also adjacent discontinuities appeared in the waviness valleys of the walls. Such occurrences justified optical and scanning electron microscopy examinations at these locations as complement analyses. Even so, the results clearly showed that the EP/EN parameter is more influential in the control of the layer dimensions and of the preform surface waviness. The LEWD parameter has more effect on reducing the heat accumulation and, consequently, assuring no wall widening as the number of deposited layers is increased. Finally, it was inferred that the possibility of affecting the thermal cycles and geometries of the resultant preforms with two independent thermal management tools expands the windows for finding optimal deposition parameters in WAAM.

Thermal management in WAAM through the CMT Advanced process and an active cooling technique