Turbulence

Nusselt number

Engineering

Phase change

Metallurgy

Materials science

Reynolds number

Enclosure

Mechanical engineering

Phase-change material

Physics

Composite material

Aluminium

Mechanics

Electrical engineering

Copper

Engineering physics

Applied Thermal Engineering

A comprehensive study was conducted to analyse the effect of fin material on PCM melting in a rectangular enclosure. Four commonly employed indicators, surface averaged Nusselt number, melting time, total stored energy and mean power, and two proposed, stored energy per mass and cost per energy stored, were used to evaluate the influence of fin material roundly. Results show that compared with the no-fin scheme, the PCM melts faster and the melting time is reduced by 41.6%, 41.0%, 40.1% and 37.2% with inserting copper, aluminum, carbon steel and steel302 fins. Significant reduction in stored energy per mass is presented by adding fins and the decline range is the highest for the copper fin scheme and the lowest for the aluminum fin scheme, which is 27% and 9.4% respectively. Among four fin schemes, the cost per energy stored is the largest for the copper, 5.6% higher than the no-fin case. The selection of fin material is affected by adopted indicators. If four commonly used indicators are considered only, the copper and carbon steel fin schemes are highly recommended, while the aluminum fin scheme is highly recommended if six indicators are considered simultaneously. A criterion, selecting fin material with higher thermal conductivity, high specific heat capacity, low density and low cost as fins, is proposed.

Effect of fin material on PCM melting in a rectangular enclosure