Electrical engineering

Physics

Channel (broadcasting)

Insertion loss

Wearable computer

Engineering

Voltage

Embedded system

Acoustics

Electrical impedance

Oscilloscope

Capacitive sensing

Electronic engineering

Computer science

IEEE Transactions on Biomedical Engineering

Human body communication (HBC) has emerged as an alternative to radio wave communication for connecting low power, miniaturized wearable, and implantable devices in, on, and around the human body. HBC uses the human body as the communication channel between on-body devices. Previous studies characterizing the human body channel has reported widely varying channel response much of which has been attributed to the variation in measurement setup. This calls for the development of a unifying bio-physical model of HBC, supported by in-depth analysis and an understanding of the effect of excitation, termination modality on HBC measurements. This paper characterizes the human body channel up to 1 MHz frequency to evaluate it as a medium for the broadband communication. The communication occurs primarily in the electro-quasistatic (EQS) regime at these frequencies through the subcutaneous tissues. A lumped bio-physical model of HBC is developed, supported by experimental validations that provide insight into some of the key discrepancies found in previous studies. Voltage loss measurements are carried out both with an oscilloscope and a miniaturized wearable prototype to capture the effects of non-common ground. Results show that the channel loss is strongly dependent on the termination impedance at the receiver end, with up to 4 dB variation in average loss for different termination in an oscilloscope and an additional 9 dB channel loss with wearable prototype compared to an oscilloscope measurement. The measured channel response with capacitive termination reduces low-frequency loss and allows flat-band transfer function down to 13 KHz, establishing the human body as a broadband communication channel. Analysis of the measured results and the simulation model shows that instruments with 50 Ω input impedance (Vector Network Analyzer, Spectrum Analyzer) provides pessimistic estimation of channel loss at low frequencies. Instead, high impedance and capacitive termination should be used at the receiver end for accurate voltage mode loss measurements of the HBC channel at low frequencies. The experimentally validated bio-physical model shows that capacitive voltage mode termination can improve the low frequency loss by up to 50 dB, which helps broadband communication significantly.

Bio-Physical Modeling, Characterization, and Optimization of Electro-Quasistatic Human Body Communication