Dry friction

Contact area

Engineering

Metallurgy

Materials science

Static friction

Lubrication

Physics

Rope

Composite material

Tribology

Structural engineering

Mechanics

Forensic engineering

Hoist (device)

Wire rope

Coefficient of friction

Friction coefficient

Wear

Friction and impact between steel wire rope always exist in multi-layer winding hoist during the winding-in process, in particular for an ultra-deep coal mine. To understand the friction and wear mechanisms of wire rope among the layers in the winding hoist, a series of sliding friction experiments were carried out using a self-made friction test rig. The results show that the coefficient of friction (COF) of the wire rope changes little with increasing load and stabilizes at approximately 0.73, but decreases with the sliding velocity under dry-friction condition. However, under lubrication condition, there is almost no effect of the contact load and sliding velocity on the COF, which stabilizes at approximately 0.35. Additionally, the temperature rise is concentrated at the contact area, and it increases with the load and the sliding velocity. The maximum temperature rise with the lubrication is much lower, approximately 10 °C, than that under the condition of dry-friction, which is approximately 103 °C. Furthermore, the maximum of the COF under the impact load is significantly lower than that for the stable contact friction. With the impact and sliding velocities increase, the maximum COF under the impact load experiences a slight increase and reaches a maximum value of approximately 0.36. As the impact load increases, the COF changes little, but the impact process occurs more than once.

The friction and wear properties of steel wire rope sliding against itself under impact load