Control (management)

Voltage

Engineering

MATLAB

Inductance

Three-phase

Operating system

Telecommunications

Computer science

Diode

Inverter

Single phase

Electronic engineering

Artificial intelligence

Sawtooth wave

Topology (electrical circuits)

Control theory (sociology)

Electrical engineering

IEEE Transactions on Industrial Electronics

This paper investigates and evaluates the performance of a single-phase split-source inverter (SSI), where an alternative unidirectional dc-ac configuration is used. Such configuration is utilized in order to use two common-cathode diodes in a single device instead of using two separate diodes, resulting in minimum parasitic inductance in the commutation paths. In this paper, the analysis and modulation of the single-phase SSI using this alternative configuration is discussed, and the analysis of the low-frequency component in the dc side is introduced. Moreover, the features behind employing the triangular, the trailing-edge sawtooth, and the leading-edge sawtooth carriers with the single-phase SSI are discussed, and the differences among these carriers are highlighted. In order to highlight the performance of the proposed SSI, a comparative study is conducted with the two-stage architecture and the single-phase quasi-Z-source inverter (qZSI). The introduced analysis is enhanced with simulation results using MATLAB/PLECS models, where a 1-kVA single-phase SSI is designed and simulated. Finally, the designed 1-kVA single-phase SSI is implemented experimentally and tested at different operating points, i.e., at different voltage gains, and a maximum efficiency of 95.5% is obtained.

Performance Evaluation of the Single-Phase Split-Source Inverter Using an Alternative DC–AC Configuration