Quantum mechanics

Anisotropy

Composite number

Engineering

Multiphysics

Residual stress

Curing (chemistry)

Epoxy

Materials science

Thermal expansion

Micromechanics

Volume fraction

Physics

Finite element method

Thermal

Composite material

Thermosetting polymer

Structural engineering

Meteorology

Journal of Composite Materials

Properties of resin and composite, especially anisotropic coefficients of thermal expansion, are very crucial to precisely determine residual stress generated in a composite part. No comprehensive study is available in the literature to determine these properties for woven composites and then its application to model residual stress in woven carbon epoxy composite parts. In the present article, experimental results on thermal coefficients of RTM6 epoxy resin as well carbon/epoxy woven composites obtained using different experimental techniques are compared with homogenised coefficients of thermal expansion results. Evolution of spring-in angle of L-shaped carbon/epoxy woven composite (during and after cure) with three different thicknesses is modelled by simultaneously solving the thermal-kinetics and thermal-chemical-mechanics coupling by using finite element code COMSOL Multiphysics. Objective was to quantify the contribution of curing and cooling to the formation of residual stress. Anisotropic properties of composite, during and after cure, required for numerical simulation are obtained using an analytical method. Variation in properties with degree of cure and thermal gradients induced in the part during fabrication are considered while modelling. Modelled properties of cured composites were compared with experimental values and were found in agreement. The spring-in angle values obtained by numerical simulation are compared with the results of the analytical model as well as experiments. Effect of variation of fibre volume fraction and presence of thermal gradients on spring-in was studied as well.

Characterisation and modelling of thermal expansion coefficient of woven carbon/epoxy composite and its application to the determination of spring-in