Physics of Metals and Metallography
IF
0.88
Papers
4,933
Papers 5,182
1 page of 519 pages (5,182 results)
Newest
#1A. E. SviridH-Index: 3
#2V. G. PushinH-Index: 22
Last. A. N. UksusnikovH-Index: 9
view all 5 authors...
Source
Source
#1Olga V. Antonova (RAS: Russian Academy of Sciences)H-Index: 12
#2I. G. Shirinkina (RAS: Russian Academy of Sciences)H-Index: 7
view all 3 authors...
Optical (OM), scanning electron (SEM), and transmission electron microscopy (TEM) were used to investigate microstructure in the interface zone of 09Mn2Si steel/Ti joint obtained by means of explosion welding. It was shown that the bonding interface had a wavy appearance. Moreover, it was observed that grains near the interface were elongated in parallel to the explosion direction. TEM study has demonstrated that the microstructure typical of states after severe plastic deformation (SPD) is obse...
Source
Source
#1R. Chaala (SIDI)
#2Djillali Bensaid (SIDI)H-Index: 13
Last. Y. Azzaz (SIDI)H-Index: 6
view all 6 authors...
The object of this study is to investigate the half-metallicity, electronic structures and magnetic in the Ba1 – xMnxO compounds under the effect of substitution of Mn impurity at the different composition x = 0.25, 0.5, and 0.75 by the use of density functional theory (DFT) based first principle calculations. The half-metallic ferromagnetism is explained by analyzing the density of states. The ferromagnetic states configuration is originated from the 3d-eg (Mn) partially filled states associate...
Source
#1N. Harshavardhana (SRM University)H-Index: 2
#2S.P. Sundar Singh Sivam (SRM University)H-Index: 8
Last. Ashish Kumar SaxenaH-Index: 5
view all 4 authors...
In electron backscatter diffraction (EBSD), kernel average misorientation (KAM), grain average misorientation (GAM), and grain orientation spread (GOS) are considered as the reflection of the extent of recrystallization. This work presents a comparative study of KAM, GAM, and GOS to bring out the best-suited parameter to determine the extent of recrystallization in pure copper. The pure ETP (electrolytic tough pitch) copper samples were characterized through EBSD at three different states: (i) d...
Source
#2Nacer ZaziH-Index: 3
Last. Jean-Paul Chopart (URCA: University of Reims Champagne-Ardenne)H-Index: 20
view all 4 authors...
In this paper, We investigate the effects of one pass severe deformation, obtained by equal channel angular pressing (ECAP) process, using dies with channel angles of 90° and 120°, on hardness, texture, and corrosion behavior, of AA1370 aluminum alloy wire. A severe deformation, by ECAP process, leads to athinning of several diffraction peaks and an increase of their angular values; modifies the texture of material from pseudo-texture to mix texture; reduces the microhardness; modifies a part of...
Source
#1Yun-long Ma (BIT: Beijing Institute of Technology)H-Index: 2
#2Ben Lin (China Academy of Launch Vehicle Technology)
Last. Yuanchun Huang (CSU: Central South University)H-Index: 10
view all 4 authors...
The η' and η strengthening precipitates in Al–Zn–Mg alloys were investigated by the first principle calculations. Results of the heat of formation and cohesive energy indicates that the model of η′ with null null null null null null null null null null null null null null null null null null null null null null null null null null null null null null null null null null null null null null null null null null null null null null null null null null null null null null null null null null null nu...
Source
Source
#1V. O. Yagovtsev (HSE: National Research University – Higher School of Economics)H-Index: 1
#2N. G. PugachH-Index: 1
Last. B.G. Lvov
view all 5 authors...
Source
12345678910
Top fields of study
This website uses cookies.
We use cookies to improve your online experience. By continuing to use our website we assume you agree to the placement of these cookies.
To learn more, you can find in our Privacy Policy.