Materials at High Temperatures
IF
1.39
Papers
1274
Papers 1323
1 page of 133 pages (1,323 results)
Newest
#1S. Li (University of Nottingham)
#2D. Purdy (EPRI: Electric Power Research Institute)H-Index: 1
Last. Wei Sun (University of Nottingham)H-Index: 31
view all 0 authors...
Source
#1Fujio Abe (National Institute for Materials Science)H-Index: 52
#2Masaaki Tabuchi (National Institute for Materials Science)H-Index: 26
Last. Susumu Tsukamoto (National Institute for Materials Science)H-Index: 16
view all 0 authors...
Soluble boron stabilises fine distributions of M23C6 carbides near grain boundaries (GBs) in 9Cr steel during creep, enhancing GB precipitation hardening, and suppresses the Type IV fracture in wel...
Source
#1Ahmed ShibliH-Index: 1
#2David J. AllenH-Index: 1
Last. Stuart HoldsworthH-Index: 18
view all 0 authors...
Source
Four sets of experimental data of a minimum creep rate of P91 in different range of stress (from 1.1 to 350 MPa) were compiled for the calibration of the linear + power law and modified sine law. A...
Source
#1Xuming Zheng (University of Huddersfield)H-Index: 1
#2Xin Yang (University of Huddersfield)H-Index: 2
Last. Qiang Xu (University of Huddersfield)H-Index: 13
view all 0 authors...
Most creep rupture is caused by the cavitation at the grain boundary. Hence, it is vitally important to develop a creep cavitation model as it is the prerequisite for the development of the creep c...
Source
#1Stuart Holdsworth (Empa: Swiss Federal Laboratories for Materials Science and Technology)H-Index: 18
The development of high-temperature damage in Ni-alloy/steel dissimilar metal welds and its influence on creep-rupture (CR) times and creep-fatigue (CF) endurances is examined. The importance of a ...
Source
#1Zhen Zhang (NJIT: Nanjing Institute of Technology)H-Index: 8
#2Ming Liu (FZU: Fuzhou University)
Last. Zheng-Fei Hu (Tongji University)H-Index: 9
view all 6 authors...
The nanoindentation creep behaviour of crept HR3C austenitic steels was investigated to study the microstructural evolution of the steel after long-term creep at 650 °C. The corresponding microstru...
Source
#1Fujio Abe (National Institute for Materials Science)H-Index: 52
The creep rupture ductility has been investigated for Gr.122 at 550 to 650 oC for up to 112,247.8 h. The obtained results are compared with those for Gr.91 and Gr.92. The degradation in reduction o...
Source
#1Rutash Mittal (Malout Institute of Management and Information Technology)H-Index: 5
#2Buta Singh Sidhu (PTU: Punjab Technical University)
Source
#1Tianlong Liu (HAUST: Henan University of Science and Technology)
#2Liujie Xu (HAUST: Henan University of Science and Technology)
view all 5 authors...
In this work, the effect of Ce and Zr on the wear performance of a nickel-saving austenitic heat-resistant cast steel at room temperature and 900 °C are investigated. The wear mechanism and strengt...
Source
12345678910
Top fields of study
Creep
Composite material
Metallurgy
Materials science
Oxide
Alloy