Electronic engineering

Nyquist–Shannon sampling theorem

Filter (signal processing)

Engineering

Linearity

Physics

Chip

Topology (electrical circuits)

CMOS

Nyquist frequency

Spurious-free dynamic range

Voltage

Computer science

Comparator

Electrical engineering

Nyquist rate

Sampling (signal processing)

Successive approximation ADC

IEEE Journal of Solid-State Circuits

This paper presents a 1.25-GS/s 7-b single-channel successive approximation register (SAR) analog-to-digital converter (ADC) that achieves a low input frequency SNDR/SFDR of 41.4/51 dB, while the SNDR/SFDR at Nyquist is 40.1/52 dB and remains still 36.4/50.1 dB at a 5-GHz input frequency (eighth Nyquist zone) without any calibration. The high and nearly constant linearity is enabled by an improved bootstrap circuit for the input switch, while the high sampling rate, the highest among recently published >34-dB SNDR single-channel SAR ADCs, is accomplished by a triple-tail dynamic comparator and a unit-switch-plus-cap (USPC) capacitive digital-to-analog converter (CDAC). To further enhance the ADC speed, the SAR logic operates in parallel to the comparator, eliminating its timing from the critical loop. The prototype chip in 28-nm bulk CMOS occupies a core area of 0.0071 mm <sup xmlns:mml="http://www.w3.org/1998/Math/MathML" xmlns:xlink="http://www.w3.org/1999/xlink">2</sup> and consumes 3.56 mW from a 1-V supply, leading to a Walden figure-of-merit of 34.4 fJ/conversion-step at Nyquist.

A 1.25-GS/s 7-b SAR ADC With 36.4-dB SNDR at 5 GHz Using Switch-Bootstrapping, USPC DAC and Triple-Tail Comparator in 28-nm CMOS